The universe is currently only about 13.8 billion years old and is still in its early stages of evolution. At this stage, hydrogen is the most abundant element in the universe.
Because it has not yet had the chance to be processed into other elements by numerous stars through fusion.
Leaving aside stars, even Gas Giant Planets are composed of more than 90% hydrogen by mass.
Although this newly designed Proton Decay Detector uses a huge amount of hydrogen, it is nothing compared to the amount of hydrogen reserves in the universe.
Li Qingsong then manufactured more Jupiter Aircraft and dropped them into the dense atmosphere of Planet 2.
Previous Jupiter Aircraft were specifically designed to collect deuterium, while protium, which is essentially ordinary hydrogen, was filtered out. These new Jupiter Aircraft are different; they will also bring back protium, which will then be transported by transshipment to a location approximately 100 billion kilometers from the Pegasus V432 Star.
This place is far from any star and any Major Planet. There isn't even a single Dwarf Planet within a radius of hundreds of millions of kilometers.
This creates an extremely stable gravitational environment in this place. Combined with an appropriate orbital speed, the gravity here is reduced to a level extremely close to zero.
In this place, Li Qingsong built a super-large Ultra-Pure Hydrogen separation plant.
Hydrogen from Gas Giant Planets is transported here and undergoes a series of processes such as pressurization and concentration to ultimately extract Ultra-Pure Hydrogen.
Its purity can even reach a level where only one atom of another element is found among billions of hydrogen atoms.
While refining Ultra-Pure Hydrogen, Li Qingsong was also constructing the main body of the Proton Decay Detector.
At a pressure of 400,000 times the atmospheric pressure, the density of hydrogen is about 0.7 grams per cubic centimeter, which is about 70% of that of water.
Based on this volume calculation, the total volume of 1.6 billion tons of hydrogen would be 2.285 billion cubic meters.
If converted to a sphere, the radius of this sphere would be approximately 650 meters.
Li Qingsong needs to build at this moment is a huge sphere with a radius of 650 meters.
This number may not seem like a large number. However, some mountains on Earth are only a little over a thousand meters high, while the sphere that Li Qingsong needs to build is already taller than those mountains!
At the same time, mountains can be viewed as cone-like structures. But what Li Qingsong is building now is a sphere!
At the same height, the volume of a sphere is far greater than that of a cone.
Compared to this sphere, even the famous Mount Heng of Southern Yue in the south of the world is utterly insignificant in comparison.
Countless special steel plates, connectors, and precision equipment from within the galaxy converged here like a flood. With the help of hundreds of thousands of General-purpose Robot, these building materials were assembled bit by bit in space.
Forces are reciprocal. To prevent the outer shell of the sphere from being ruptured by the enormous internal pressure, Li Qingsong also mobilized a large number of high-strength ropes, the kind used to build Space Elevator, and wrapped them around the huge metal shell, securing them in place.
With the main structure completed, the next step was the most intricate and challenging internal construction.
Inside this spherical shell, Li Qingsong installed a large number of magnetic field control devices, creating an extremely strong magnetic field. At the same time, construction began on the inner layer of the Proton Decay Detector about five meters inside the shell.
The inner layer is only 0.5 centimeters thick, and its material strength is ordinary, making it impossible for it to withstand pressure of 400,000 times the atmospheric pressure.
However, this layer of material has two characteristics.
Firstly, it has extremely strong resistance to hydrogen embrittlement.
Because of its small molecular weight, hydrogen gas can be squeezed into the structure of other substances under high pressure, causing a decrease in the strength of those substances. This material can effectively prevent this from happening.
Secondly, it has good electrical conductivity, which means it can be manipulated by a magnetic field.
At that time, the magnetic control device manufactured by Li Qingsong will inject enormous pressure into it, using it as a transfer point to apply pressure to the hydrogen inside.
While constructing the main body of the detector and the Ultra-Pure Hydrogen refining plant, Li Qingsong also simultaneously launched a third construction project.
A Nuclear Fusion power plant specifically designed to support it.
Magnetically controlled equipment consumes an enormous amount of electricity. Furthermore, it's not a one-time event once pressurization is complete. It must operate continuously, without stopping for even a moment, to maintain that pressure.
In fact, according to Li Qingsong's estimate, maintaining the operation of this detector would require an average of about 20 billion kilowatt-hours of electricity per hour!
This is roughly equivalent to the electricity consumption of an entire country in the era of Earth's nations, yet at this moment, such a massive amount of electricity is only used to maintain the daily operation of a single probe.
If a Deuterium-Tritium Fusion plant has an installed capacity of 3 billion kilowatt-hours, then just to power the operation of this one detector, it would be necessary to build seven power plants around it!
In this deep space, far from any large celestial bodies, Li Qingsong rapidly carried out various construction projects.
Even with Li Qingsong's Industrial Capacity, it took him almost a whole year to build this detector.
Then, Ultra-Pure Hydrogen began to be injected.
Ultra-Pure Hydrogen, refined through multiple processes, was injected into the inner spherical shell via a dedicated pipeline. Soon, the pressure inside the inner shell rose to approximately one atmosphere.
The inner shell, which was originally somewhat shriveled due to its relatively soft texture, now swelled up like a balloon being inflated, thanks to the internal atmospheric pressure. It returned to its normal spherical shape, with no more dents or shriveling on the outside.
If the internal pressure is increased further, it may be torn apart directly.
At this point, the magnetic control equipment installed inside the outer spherical shell begins to work.
With a massive power supply, based on a mode similar to magnetic levitation or Magnetic Confinement, external pressure is uniformly applied to every molecule and every atom of the inner spherical shell.
The internal pressure on the inner spherical shell is converted into the pressure on the outer spherical shell.
The Space Elevator material atop the outer spherical shell firmly binds it, eliminating all pressure. Simultaneously, the thick armor blocks most of the external radiation, preventing it from affecting internal detection.
With the continuous injection of hydrogen, the atmospheric pressure inside the inner shell rapidly increased.
Five times the atmospheric pressure, ten times, fifty times, one hundred times, one thousand times...
At this moment, the pressure inside the inner spherical shell is almost the same as the atmospheric pressure at the bottom of the Mariana Trench.
If a clone were to enter the inner spherical shell at this moment, he would be instantly crushed into a meat patty.
Even under such immense pressure, the soft inner spherical shell remained intact under the suppression of the magnetic control device.